|
|
Just like the
AGA-URO-LIFT, the AGA-URO-MED examination chair as depicted in
figs. 1 & 2 is equipped with a seat-synchronized gyroscopic utility sink
that has a down pipe as well as an inflow. Due to seat synchronization,
the splash risk is obviously minimized even in a raised pelvis position.
The down pipe tube is located on the underside and is ø32mm in diameter;
the side inflow tube requires a ø½-inch diameter hose.
Pelvic positioning from
865 up to 1175mm (measured from seat front) is attained by an independent,
maintenance free electric motor with ultra low-noise emission, controlled
with the aid of a separate pneumatic foot switch.
Our AGA-URO-MED
examination chair differs from the AGA-URO-LIFT in that it is non
height adjustable, it is instead supplied with a pivoted retractable foot
rest with dimensions of 490 * 320 * 250 mm (B*D*H).
Technical
specifications of the centrifugal sink:
- Supply hose Ø R 1/2 "
- Drain hose DI=32 mm Ø
Drive specifications:
230VAC, 50Hz, 2.4 A, 510 W, IP 55, v=14 mm/s, 7000N
The base and column
covers used on our AGA-URO-MED examination chair are impact
resistant and are just as simple to clean as the attached components.
An electric socket is fitted at the back of the column for electrical
appliances, e.g. for colposcopy purposes, as well as appropriate
fittings for a colposcopy holder, for either left or right hand side
mounting.
The all-inclusive price comprises of a pair of ring shaped arm
supports, a pair of OP-Rails pre-attached onto the chair frame, a pair
of leg rests with plastic shells and Göpel type fixing clamps, a paper
roll holder, pivoted retractable foot rest and a stainless steel
gyroscopic utility sink complete with siphon, adjustable spray
nozzles, water-inlet and drain tubes.
Finally, both the AGA-URO-LIFT and AGA-URO-MED
examination chairs can be equipped with an electromotive adjustable
backrest controlled with the aid of a separate pneumatic foot switch;
available per surcharge under the additional article code ERV.
|
|
