AGA Sanitätsartikel GmbH

Löhner Straße 198b
D-32584 Löhne
Telefon :  +49 (0) 5731 82283
Telefax : +49 (0) 5731 81976

 

OP, Multi-Purpose,

X-Ray Tables and Accessories

 
Examination Chairs
 
Phlebological Tables
 
Cardiography Tables
 

Transfusion Tables

and Chairs

 
Stainless Steel Tables
 
Multi-Purpose Tables
 
Universal Tables
 
Therapy and Gymnastics Tables
 
Massage Benches
 
Paravents, Furniture, Miscellaneous and Accessories

 

 

 

 

 

 

   

 

   

These urological examination chairs also express our fine attention to detail.

Both AGA-URO-LIFT and AGA-URO-MED examination chairs are equipped with a seat-synchronized gyroscopic utility sink that has a down pipe as well as an inflow. Due to this seat synchronization, the splash risk is obviously minimized even in a raised pelvis position. The down pipe tube is located on the underside and is 32mm Ø in diameter; the side inflow tube requires a ½-inch Ø diameter hose.

The AGA-URO-LIFT examination chair as depicted here in figs. 1 & 2 has a stepless, electromotive height adjustability ranging from 650 up to 1160 mm (measured from seat front), therefore allowing an ideal user working height. Furthermore, our AGA- URO-LIFT`s low seating height eliminates the necessity of a retractable footrest. Different backrest thickness ranging from 75mm at the lower end up to 140mm at the top in conjunction with an 80mm thick upholstered seat (with an extra-large pelvic cut-out) also provide a high degree of comfortability, which is due to the use of various types of padded foaming each with diverse thickness. Additionally, because of this wedge-shaped backrest a separate neck bolster is not required.

 

Both pelvic positioning and seat height adjustability are each individually attained by independent, maintenance free electric motors with ultra low-noise emission, controlled with the aid of separate pneumatic foot switches.

The base and column covers used on our AGA-URO-LIFT examination chairs are impact resistant and are just as simple to clean as the attached components. An electric socket is fitted at the back of the column for electrical appliances, e.g. for colposcopy purposes, as well as appropriate fittings for a colposcopy holder, for either left or right hand side mounting.

The all-inclusive price comprises of a pair of ring shaped arm supports, a pair of OP-Rails pre-attached onto the chair frame, a pair of leg rests with plastic shells and Göpel type fixing clamps, a paper roll holder and a stainless steel gyroscopic utility sink complete with siphon, adjustable spray nozzles, water-inlet and drain tubes.

Drive specifications of each motor:
Dual 230VAC, 50Hz, 2.4 A, 510 W, IP 55, v=14 mm/s, 7000N

 

 

 

 

Back

Page 1 2 3  4 5 6 7  

Forward