|
|
Our AGA-MED
gynaecological examination chair differs from the AGA-LIFT in
that it is non height adjustable, it is instead supplied with a
pivoted retractable foot rest with dimensions of 490 x 320 x 250 mm (BxDxH).
Pelvic positioning from 865 up to 1175mm (measured from seat front) is
attained by an independent, maintenance free electric motor with ultra
low-noise emission, controlled with the aid of a separate pneumatic
foot switch.
The AGA-MED’s all-inclusive price comprises of a pair of ring
shaped arm supports, a pair of OP-Rails pre-attached onto the chair
frame, a stainless steel pan, a pair of leg rests with plastic shells
and fixing clamps, a paper roll holder (which can be alternatively
fitted onto side of seat upon request) and a retractable foot rest.
Fittings for a colposcopy holder, for either left or right hand side
mounting.
Further depicted accessories with appropriate descriptions are on page
85.
Drive specifications:
230VAC, 50/60Hz., 3,7A, 850W, IP55, v=14 mm/s, 7000N
Further accessories are shown and described in the
section Paravents,
Furniture, Miscellaneous and Accessories (page 5).
The AGA-PERMO
gynaecological examination chair was specifically designed to operate
all functions fully independent of an electrical power source. This
feature therefore allows us to offer the AGA-PERMO at a very
attractive price.
A foot pedal located underneath the retractable footrest attains
risible pelvic positioning from 830 up to 1140mm (measured from seat
front). The manually adjustable pelvic positioning in combination with
the gas-spring operated backrest will enable Trendelenburg positioning
of up to 35°. Furthermore, the gas-spring operated backrest itself is
adjustable up to 63°.
The base and column covers used on the AGA-PERMO are impact
resistant and are just as simple to clean as the attached components.
It has a generously dimensioned base construction and is equipped with
levelling screws to ensure even further stability.
The AGA-PERMO’s all-inclusive price comprises of a pair of ring
shaped arm supports, a pair of OP-Rails pre-attached onto the chair
frame, a stainless steel pan, a pair of leg rests with plastic shells
and fixing clamps, a paper roll holder (which can be alternatively
fitted onto side of seat upon request), a neck bolster and a
retractable foot rest.
Fittings for a colposcopy holder, for either left or right hand side
mounting.
|
|
