|

Our
AGA-PHLEBO-LIFT and PHLEBO-MAT blood vein treatment tables
as described on the previous page have been modified here to perform
cardio graphic tilt-table examinations or tilt-testing.
The KT-1062/E tilt-table is equipped with a maintenance free, water
resistant, smooth-running motor for stepless tilt adjustment
controlled by a pneumatic foot-operated switch enabling
manoeuvrability into virtually any position from near vertical through
to horizontal and even into the shock position tilted 20° negative (in
approx. 14 seconds) should a patient lose consciousness.
The all-inclusive price of the KT-1062/E tilt-table comprises of a
pair of 1700mm long OP-Rails pre-attached onto the table frame, a
stepless adjustable headrest, a pair of ring shaped armrests with
fixing clamps, a black footstep and a strapping belt (2200*200mm –
L/B) to secure the patient.
The base and column covers used are impact resistant and are just as
simple to clean as the attached components. It has a generously
dimensioned base construction and is equipped with an additional
pull-out support to ensure adequate stability even when the table is
set in a near vertical position.
To enable mobility the KT-1062/E tilt-table can be supplied with an
optionally available central-locking castor system under article no.
LR/Z-50 and can also be fitted with a P-2065/A paper roll holder. You
can close the cut-out at the foot end with the upholstery insert order
No. PEF-1043, which is available against a surcharge.

A stainless steel angle indicator for either left or
right hand side mounting is also optionally available under article no.
WM-30.

The KT-1060/EE tilt
table differs from the KT-1062/E in that it is further enhanced by
height adjustability, and is therefore equipped with dual maintenance
free, water resistant, smooth-running motors for stepless height and
tilt adjustability and controlled by two pneumatic foot-operated
switches.
Thus, the all-inclusive price of the KT-1060/EE tilt-table comprises
of a pair of 1700mm long OP-Rails pre-attached onto the table frame, a
stepless adjustable headrest, a pair of ring shaped armrests with
fixing clamps, a black footstep and a strapping belt (2200*200mm –
L/B) to secure the patient.
The EKAT-1062/E is
in addition to the aforementioned additionally equipped with a
detachable cut-out (included in price; dimensions 300*250mm – L/B)
when cardiac examinations with an ultrasonic transducer are necessary.

The EKAT-1060/EE
tilt table differs from the EKAT-1062/E in that it is further enhanced
by height adjustability, and is therefore equipped with dual
maintenance free, water resistant, smooth-running motors for stepless
height and tilt adjustability and controlled by two pneumatic
foot-operated switches.
To further secure the patient we recommend an additional second
strapping belt (2200*200mm – L/B), optionally available under PG-220.
Drive specifications:
230 VAC, 50 Hz, 2.4 A, 510 W, IP 55, v=14 mm/s, 7000N.
|